Home Services Tile Injection About Contact
Trusted Quality Since 2005

Waterproofing
Specialists
You Can Trust

Commercial, residential and industrial waterproofing, tile injection, crack injection, roof membranes and specialist leak repair across Cairns and Far North Queensland.

20+ Years Experience
 Licensed & Insured
 Commercial & Residential
 Local to FNQ
20+Years Experience
1000sProjects Completed
100%Licensed & Insured
FNQBased & Local

Don't Replace.
Repair.

Modern injection systems can solve problems that used to mean demolition — at a fraction of the cost, with a fraction of the disruption. Loose tiles rebonded in hours. Leaking concrete sealed from within. Waterproofing membranes restored without tearing up your floor. We've been doing this across FNQ since 2005.

Tile Injection

Loose and drummy tiles rebonded without removal. No jackhammer, no dust, no mismatched replacements. Ready to walk on the same day.

Crack Injection

Concrete cracks sealed from the inside using polyurethane or epoxy under pressure. Stops active leaks in basements, car parks, retaining walls and slabs — without excavation.

Waterproof Membranes

Liquid and sheet membrane systems for roofs, balconies and wet areas — specified and installed for Queensland's tropical UV and wet season conditions.

Common Problems

Water Getting In Where It Shouldn't?

These are the four most common waterproofing failures we deal with across FNQ. Each one requires a different approach — and the right diagnosis is the most important step.

01

Underground Car Parks & Basement Leaks

Active water ingress through concrete walls, slabs and construction joints in below-ground structures. Concrete cancer and structural corrosion follow if left untreated.

Injection Waterproofing →
02

Loose, Hollow & Drummy Tiles

That hollow knock when you tap a tile means the adhesive bond has failed. Water gets into the void, spreads to surrounding tiles, and attacks the waterproofing below.

Tile Injection →
03

Cracked Concrete Structures

Cracks in concrete walls, slabs and retaining structures are direct water pathways. Water carries chlorides that corrode reinforcing steel and weaken the structure from inside.

Crack Injection →
04

Failed Balcony & Roof Membranes

Queensland's UV, heat cycling and wet season rainfall degrade membranes faster than anywhere else. A failed membrane on a balcony or roof causes damage to everything below it.

Membrane Waterproofing →
What We Do

Our Waterproofing Services

From a single drummy tile to a full commercial waterproofing system — the right diagnosis, the right product, done properly.

Tile Injection

Permanently rebond loose and drummy tiles on floors, walls, pool surrounds and bathrooms — without removing them. No demolition, no mismatched replacements, ready to use same day.

Learn more →

Concrete Crack Injection

Polyurethane and epoxy injection systems that seal cracks from within — stopping active leaks and restoring structural integrity without excavation or major disruption.

Learn more →

Roof Membranes

Liquid and sheet membrane systems for flat and low-pitch roofs. UV-stable, flexible and rated for FNQ's tropical downpours. Repairs and full replacements.

Learn more →

Balcony & Deck Waterproofing

Balconies over occupied space have zero tolerance for failure. We assess, prepare and install membrane systems that handle FNQ's extremes — wet season rainfall, UV and thermal movement.

Learn more →

Commercial Waterproofing

Strata buildings, body corporates, hotels, car parks and industrial facilities across FNQ. Minimal disruption to tenants, full compliance documentation, licensed and insured.

Learn more →

Grout & Silicone Sealing

Failed grout and cracked silicone joints are the most common water entry point in wet areas. We regrout and reseal bathrooms, expansion joints, facades and external junctions.

Learn more →

Tile Replacement

When injection isn't the right answer — cracked tiles, deteriorated substrate or failed waterproofing beneath — we remove, prepare, waterproof and relay properly.

Learn more →

Retaining Walls

Retaining walls face sustained hydrostatic pressure from the soil and water behind them. We waterproof faces, seal cracks and address drainage to relieve that pressure properly.

Learn more →

Subfloor Leak Solutions

Hidden moisture beneath floor coverings causes adhesive failure, mould and substrate damage before you can see it at the surface. We locate the source and fix it properly.

Learn more →
Our Process

How Every Job Works

No guesswork, no unnecessary upselling. We find the problem, recommend the right fix, do it properly, and stand behind it.

01

Site Inspection

We assess the problem properly — moisture mapping, tap testing, crack tracing. Identifying the source, not just the symptom.

02

Honest Diagnosis

We recommend the right system for your specific substrate, exposure and budget. If injection won't hold, we'll tell you before we start.

03

Professional Repair

The right materials, applied correctly, with minimal disruption to your home, tenants or operations.

04

We Stand Behind It

If the problem returns through our fault, we come back and fix it. After 20 years in FNQ, our reputation is built on work that holds.

Need Professional Waterproofing?

Whether it's a leaking car park, failed balcony membrane or loose tiles — get in touch for a free inspection and straight advice from people who've been doing this for over 20 years.